INTU STRIP FS
INTU STRIP F
March 16, 2018
INTU FR BOARD A
March 19, 2018
Show all
INTU_STRIP_FS_500

INTU STRIP FS

The firestop seal with self-adhesive tape INTU STRIP FS is made of graphite-based material and equipped with self-adhesive layer. The material swells under the influence of high temperature, increasing its volume 35 times. The expanding product prevents the spread of fire through joints and gaps in the fire door. Fire resistance class up to EI 240*.


 INTU STRIP FS TDS EN

Content in accordance with TDS PW_1.14

Category:

Where to use

The INTU STRIP FS is designed for sealing gaps in fire doors.

Compliance

Compilance:

  • Tested to EN1364-1:2014-03 + Ap1:2016 10P
  • Door fire test report LZP43-02580/16/Z00NZP
  • Swell pressure report LZP08-2580/16/Z00NZP
  • Swell height report LZP09-2580/16/Z00NZP
  • DoP 13/2019
  • TDS
  • SDS

Availability

  • rolls with a length of 10/25/50/100 m
  • thickness from 2 to 2.5 mm
  • width from 10 to 60 mm

Installation

The seal is mounted around the door in previously prepared grooves. In order to install the seal, remove the protective layer of the adhesive tape, align the seal and press it exactly at the milled groove along its entire length. Seals should not be cut after applying to surface.

 



Transport & storage

It is recommended to store in dry internal conditions at temperatures between + 5°C and + 25°C.

 

 INTU STRIP FS SDS

This site uses cookies. More information.

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close