INTU STRIP F
INTU FR EJ SEAL
March 16, 2018
INTU STRIP FS
March 16, 2018
Show all
INTU_STRIP_F_500

INTU STRIP F

The firestop seal INTU STRIP F is made of graphite-based material. The material swells under the influence of high temperature, increasing its volume 35 times. The expanding product prevents the spread of fire through joints and gaps in the fire door. Fire resistance class up to EI 240*.


 INTU STRIP F TDS EN

Content in accordance with TDS PW_1.14

Category:

Where to use

The INTU STRIP F is designed for sealing gaps in fire doors.

Compliance

Compilance:

  • Tested to EN1364-1:2014-03 + Ap1:2016 10P
  • Door fire test report LZP43-02580/16/Z00NZP
  • Swell pressure report LZP08-2580/16/Z00NZP
  • Swell height report LZP09-2580/16/Z00NZP
  • DoP 13/2019
  • TDS
  • SDS

 

Availability

  • rolls with a length of 10/25/50/100 m
  • thickness from 2 to 2.5 mm
  • width from 10 to 60 mm

Installation

The seal is installed around the door in previously prepared grooves. In order to install the seal, use your own gluing technology; fit it exactly to the milled groove along its entire length. Seals should not be cut after applying to surface.

Transport & storage

It is recommended to store in dry internal conditions at temperatures between + 5°C and + 25°C.

 

 INTU STRIP F SDS

This site uses cookies. More information.

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close